250kg Trolleylift
The Trolleylift is a floor level loading service lift, ideal for reliably moving larger loads in busy environments. Ideally installed with a shallow pit depth or, if no pit is possible, a ramp can provide access at the lower floor.
| MODEL | CAPACITY | CAR | ENTRANCE | SERVING HEIGHT (variable) | SHAFT | PIT DEPTH | HEAD ROOM |
||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| WIDTH | DEPTH | HEIGHT | WIDTH | HEIGHT | WIDTH | DEPTH | |||||
| 250HP | 250kg | 1000† | 950† | 1350 | 795† | 1240 | FLOOR LEVEL |
1320 | 1320 | 350* | 2800 |
| 250CP | 250kg | 1000† | 950† | 1350 | 770† | 1240 | FLOOR LEVEL | 1320 | 1320 | 350* | 2800 |
All Dimensions are nominal and in mm.
* Important Note:- Pit & Headroom
The Trolleylift normally serves at floor level and would require a pit in the lowest floor. If you are unable to provide a pit the Trolleylift can be installed to serve at 350mm above the lowest floor and a ramp will need to be provided by your builder. A reduction in the pit depth for the 250kg model is possible - please contact us for details.
† Notes:-
When the car is fitted with collapsible gates on a through or adjacent entry arrangement, the car depth/width is reduced by a further 50mm nominal.
Safe Maintenance Access
A service engineer must be able to access the motor compartment in a safe manner. The lift owner must provide a safe means of access up to the motor compartment.
Access doors to the motor compartment are required on one or two faces of the lift shaft, depending on the configuration of the lift. The doors must be hinged and lockable.
Our builders work drawings contain more detailed information on this topic but please do not hesitate to contact us if you have any questions.
For further advice please contact us on
01264 351922.
SPECIFICATION
Car: Constructed in mild steel, finished in a tough grey baked enamel.
Speed: 0.17m/s.
Entrances: Landing entrances are protected by a single hinged steel door with grey baked enamel finish as standard, or optional concertina shutter leaf gate with galvanised finish. All doors are fitted to our structure and have safety locks to comply to safety regulations.
Car entrance protection: In order to meet the Essential Safety protection: Requirements (ESRs) of the Machinery (Safety) Regulations, the lift car should be supplied with car entrance protection. This protects goods from falling out of the lift car whilst it is in motion. In order to comply with the requirement a collapsible gate is fitted as standard.
Entry choice: Up to three entrances can be fitted on each floor.
Control: Fully automatic push button control with call and despatch facilities at each landing entrance.
Indicators: “Lift arrival”, “lift occupied” and “lift position” indicators are fitted at each entrance for extra reassurance, together with an audible lift arrival buzzer.
Travel: Up to 6 stops over a total distance of 18m of travel.
Mounting: The Trolleylift is supplied in a structure-supported frame. We do not require a separate motor room or “load-bearing” lift shaft. A solid base and support at each floor is all that is needed from your building. For details, please ask for our builders work details.
Motor: Mounted at the top of the lift structure, the smooth, quiet motor drives a high quality reduction gearbox fitted with a traction vee-sheave. An electro-magnetic disc brake is supplied, with emergency release mechanism. The reliable controller and counter-balance drive system ensure electrical consumption is minimal.
Safety: Complies with the Essential Safety Requirements (ESRs) of the Machinery (Safety) Regulations 1992, also known as the Machinery Directive and EN 81-3 where applicable.
Additional options include: Concertina shutter leaf landing gate, intercom system and load weighing.